Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

 SFPUSB HostSD Card
"J4 2x5 Pin Header(2.54)"

GPIO
"J20/J10 each 2x25 Pin Header(2.54)"

 

XMOD (JTAG/UART)

"JX1 2x6 Pin Header (2.54)"

GPIO

(JTAG/UART/MGT REFCLK)

"J3 2x8 Pin Header(2.54)"

TE0710(error)(error)(star),3.3V B16 I/O(star)(9)(tick)(star)(8)
TE0711(error)(error)(star),1.8V B16 I/O(star)(9)(tick)(tick), B34 CLK input
TE0712(tick)(error)(star),  B13 I/O(star)(9)(tick)(tick), B34 CLK input
TE0713(tick)(error)(star),  B13 I/O(star)(9)(tick)(tick)
TE0715 (Warnung)(Warnung)(10)(tick)(tick)(star)(7)(star)(9)(tick)(tick)
TE0715-30 (Warnung)(10)(tick)(tick)(star)(7)(star)(9)(tick)(tick)
TE0720 (Warnung)(Warnung)(10)(error)(tick)(star)(7)(star)(9)(tick)(tick), B34 CLK input
TE0741(tick)(error)(error),MGT's(star)(9)(tick)(tick)
TE0820 (Warnung)(10)(tick)(tick)(star)(6)(star)(9)(tick)(tick)
TE0841(tick)(error)(error),MGT's(star)(9)(tick)(tick)
  • TEBA0841 has no dedicated power plug connector for 3.3V main power. External Power Supply must be connected to  J17, J20, J4 or J3 3.3V Pin. Do not use XMOD for power supply.
  • TEBA0841-REV02 VCCIOB and VCCIOC are not connected.
  • (6) Works, but without carrier board modification out of specification: TE0706 SD Levelshifter powered fix by 1.8V, TE0820 SD MIO-Bank by 3.3V.
  • (7) SD signals only, no SD-Card connector
  • (8) CLK not connected on TE0710
  • (9) Check schematics  or TE Master Pinout Excel Sheet for detailed connection and IO Bank power supply
  • (10) With TEBA0841-01 is Boot Mode not selectable., please contact Trenz Electronic Support, if you need a Zynq or ZynqMP Module with TEBA0841