Legend:
: Attention: Carrier/Module combination only with special condition or PCB modification possible
: Supported
: Supported with limitations
: Not Supported
: Table currently not complete, see TRM of module and carrier
| | FMC(1) | FMC Vadj | PMODS | ETH | HDMI | CL Connector(5) | SD Card | USB Host | VBATT |
|---|
| TE0710 | | | | | | , N.C. | | | |
| TE0711 | | | | | | | | | |
| TE0712 | | | | ,100 MBit* | | ,MGT's | | | |
| TE0713 | | | | | | | | | |
| TE0715-15 | | | | | | ,MGT's | | | , RTC and Key RAM |
| TE0715-30 (2) | | ,Max 1.8V | | | | ,MGT's | | | , RTC and Key RAM |
| TE0720 | | | | | | ,LVDS | | | , RTC and Key RAM |
| TE0741 (4) | | | | | | ,MGT's | ,MGT's | | |
| TE0820 (2) | | | | | | | | | |
| TE0841 (2)(3) | | | | | | ,MGT's | ,MGT's | | , Key RAM |
- (1) FMC is a LPC Connector (no gigabit transceivers) on TE0701: I2C and JTAG access over CPLD.
Separate TE0701_FMC_PINOUT table (PDF/XLSX) is available on: Trenz_Electronic Download-Pinout - (2) HP IO Banks only support 1.8V
- (3) MGT's Lanes goes to SD-Level shifter, it's recommended to desoldering level shifter
- (4) MGT's Lanes goes to SD-Level shifter, but module side 1.8V is not connected
- (5) CL Connector is usable as Cameralink only with module that map LVDS pins to this connector
- (2) HP IO Banks only support 1.8V
- (3) MGT's Lanes goes to SD-Level shifter, it's recommended to desoldering level shifter
- (4) MGT's Lanes goes to SD-Level shifter, but module side 1.8V is not connected
- (2) HP IO Banks only support 1.8V
- (3) MGT's Lanes goes to SD-Level shifter, it's recommended to desoldering level shifter
- (4) MGT's Lanes goes to SD-Level shifter, but module side 1.8V is not connected
- (2) HP IO Banks only support 1.8V
- (3) MGT's Lanes goes to SD-Level shifter, it's recommended to desoldering level shifter
- (4) MGT's Lanes goes to SD-Level shifter, but module side 1.8V is not connected