Page History

...

1. TE USB FX2 module is turned off (powered off);
2. EEPROM connection disabled (EEPROM switch is set in a way to disable EPPROM connection to USB FX2 microcontroler);
3. TE USB FX2 module turned on (powered on);

4. TE USB FX2 module is inserted in the USB port of the computer (aka plugged in, aka attached);
   

5. module enumerates in recovery mode (VID = 0x04B4, PID = 0x8613); 
6. Install Cypress USB Generic Driver if needed ⁽¹⁾;
7. EEPROM connection enabled (EEPROM switch is set in a way to enable EPPROM connection to USB FX2 microcontroler);
   EEPROM connection shall always be enabled during EEPROM programming;
8. Cypress firmware update tools and OpenFutNet can read and write the EEPROM.

...