Page History
...
- disconnect the module if it connected or leave the module unconnected;
- configure turn off the TE USB FX2 module;
- set “EEPROM” switch to EEPROM connection disabled module such that the USB microcontroller will provide its default vendor ID and device ID to the USB host. To do it, set “EEPROM” switch to “OFF” state (EEPROM disconnected from USB microcontroller) . Refer to your module manual for switch location (1);
- turn on the TE USB FX2 module;
- connect the module to the host computer through the USB interface;
...
After that, the EEPROM should be programmed with the right Vendor ID / Device ID pair; see firmware recovery.
(1) Refer to your module manual for switch location.
Overview
Content Tools