Page History

...

1. TE USB FX2 module is turned off (powered off);
2. EEPROM connection disabled (EEPROM switch is set in a way to disable EPPROM connection to USB FX2 microcontroler);
3. TE USB FX2 module turned on (powered on);
   1. if the TE0300 module is used, the S2 switch must be turned on (RUN);
   2. if the TE0320 module is used, the S1D switch must be turned on (RUN);

4. TE USB FX2 module is inserted in the USB port of the computer (aka plugged in, aka attached);
   

5. module enumerates in recovery mode (VID = 0x04B4, PID = 0x8613); 
6. Install Cypress USB Generic Driver if needed ⁽¹⁾;

7. EEPROM connection enabled (EEPROM switch is set in a way to enable EPPROM connection to USB FX2 microcontroler);
   

   Warning
   EEPROM connection shall always be enabled during EEPROM programming.

8. Cypress firmware update tools (Cypress USB Console recovery boot,Cypress USB Control Center recovery boot) and OpenFutNet (OpenFutNet recovery boot) can read and write the EEPROM.

   For example using CyControl (Cypress USB Control Center).

Using Cypress firmware update tools with generation 2 modules does require a recovery boot, in order to force enumeration as Cypress USB Generic Driver.

...