Versions Compared

Old Version 4

changes.mady.by.user Sergio Pavesi

Saved on

compared with

New Version 5

changes.mady.by.user Sergio Pavesi

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • set “EEPROM” switch to EEPROM connection disabled (EEPROM disconnected from USB microcontroller) (1);
  • turn on the TE USB FX2 module;
    • if the TE0300 module is used, the S2 switch must be turned on (RUN);
    • if the TE0320 module is used, the S1D switch must be turned on (RUN);
  • connect the module to the host computer through the USB interface;
  • Open "Device Manager" using one of this two procedure:
    • Start\Control Panel\System and Security\System\Device Manger
    • write devmgmt.msc in the line “Search programs and files”
    to go directly to the Device Manager

  • wait until the operating system detects new hardware

    and starts the hardware assistant;

    ; module enumerates in recovery mode

    Scroll pdf title
    titles

    Cypress Generic USB Device
    is already installed?

    		Image of Windows "Device Manager"
    (error)Image Added
    (tick)Image Added
  • you could set “EEPROM” switch to enable EEPROM connection (EEPROM connected to USB FX2 microcontroller) (1);
  • starts the hardware assistant;
  • answer the hardware assistant questions as shown in the following images (images to add): you should select the driver for your Operating System;
  • Check that, in the “Device Manager” under “USB-Controller”, the “Cypress Generic USB Device” has been added.

...