Page History
...
Page properties | ||||
---|---|---|---|---|
| ||||
Notes :
|
Board to Board (B2B)
...
FPGA IOs
Zynq SoC's I/O banks signals connected to the B2B connectors:
Scroll Title | |||||||||||||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| |||||||||||||||||||||||||||||||||||||||||||
|
JTAG Interface
JTAG access to the TE0716 SoM through B2B connector JP2.
@Guillermo: Hier kurz sagen das JTAG auch auf FTDI geht und nur einer JTAG bedienen darf
Scroll Title | ||||||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||||||||||||||||||||||||
|
...
UART Interface
@Guillermo: Hier die JP1 Stecker Pins wo UART rausgeführt wird und sagen das das mit FTDI geteilt ist
USB Interface
@Guillermo: Hier die JP2 Stecker Pins wo USB rausgeführt wird
ETH Interface
@Guillermo: Hier die JP11 Stecker Pins wo ETH rausgeführt wird
ADC Interface
@Guillermo: Hier die JP1 Stecker Pins wo ADC rausgeführt wird
PWM Interface
@Guillermo: Hier die JP2 Stecker Pins wo PWN rausgeführt wird
Micro USB -JTAG/UART
@Guillermo: Hier kurz erklären das UART JTAG über FTDI möglich ist und Hinweis das JTAG auch auf B2B J2 geht und nur einer JTAG bedienen darf
MIcro SD Socket
@Guillermo: Hier kurz ob direkt an PS angeschlossen oder Levelshifter oder ob die SD push pull oder push push ist
MIO Pins
@Guillermo: Hier eine Liste an MIOs die schon direkt eine Interface zugeordnet sind QSPI, SD, USB, ETH.... also die MIO gruppe und welchem Interfache die Zugeordnet werden muss in Vivado und nicht jeden Pin einzeil "Siehe das Beispiel im "Page properties unter meinen eintrag hier. Das Kapitel dient dazu in Vivado die basis PS MIO Interfaces einzustellen ohne in den Schaltplanz zu schauen zu müssen
Page properties | ||||||||
---|---|---|---|---|---|---|---|---|
| ||||||||
you must fill the table below with group of MIOs which are connected to a specific components or peripherals, you do not have to specify pins in B2B, Just mention which B2B is connected to MIOs. The rest is clear in the Schematic. Example:
|
...