Versions Compared

Old Version 10

changes.mady.by.user Maksim Tserabei

Saved on

compared with

New Version 11

changes.mady.by.user Maksim Tserabei

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Affected Product

NoteNote
TE07104x5 Seriesissue fixed Revision 3 and newer with Diode between PROG_B and INT_B
TE07114x5 Seriesissue fixed Revision 2 and newer with Diode between PROG_B and INT_B
TE07124x5 Seriesissue fixed Revision 4 and newer with Diode between PROG_B and INT_B
TE07134x5 Series
TE07143x5 Series
VCCIO_0 is no sourced by internal 1.8V		issue fixed Revision 4 and newer with Diode between PROG_B and INT_B
TE07414x5 Seriesissue fixed Revision 5 and newer with Diode between PROG_B and INT_B
TE08414x5 Seriesissue fixed Revision 3 and newer with Diode between PROG_B and INT_B


Description: 

On 4x5 Module power switch (TPS27082LDDCR) will forward 3.3VIN voltage to 3.3V power rail.  The switch is enabled by the internal power good signal from DCDC which provides the internal core voltages. This complies with the Xilinx power up sequencing.  INIT_B Pin will be release with pullup on this 3.3V power rail which force the FPGA together with PROGRAM_B to boot from QSPI Flash (See UG470).  However, a too slow increase of the 3.3VIN voltage can result in the internal voltages being generated, but the 3.3V voltage is not yet sufficient for the QSPI flash, but high enough that the FPGA try to boot from QSPI flash. In this case QSPI flash access can failed.

...