Number | Note |
| Letter | Note |
---|
1 | S2- Reset Button S2 |
| A | P1 - PMOD 3.3V I2C Bus |
---|
2 | LEDs D7 - LED D7 Red (Usage: status) and || D6 - LED Green (Usage: status) |
| B | J9 - Audio Enclosure |
---|
3 | S1 - Reset Button S1 |
| C | P3 - PMOD 3.3V I2C Bus |
---|
4 | J25 - Power Jack J25, 2.1mm (optional 12V power input) |
| D | J17 - I2C (for optional module PLL access) |
---|
5 | S5 - DIP Switch for Boot Mode and FMCVADJ |
| E | J6/15 - Firefly - GTH |
---|
6 | J10 - Enclosure Pin header(Reset and Power Button, HD LED (Usage: status/user) and Power LED (Usage: status/user)) |
| F | J31 - SATA |
---|
7 | S4 - DIP Switch for CPLD access and power control |
| G | J21/22 - Firefly - loopback only |
---|
8 | J12 - XMOD J12 with green dot for Module JTAG and UART, XMOD LED D4 Red used for status information |
| H | J11 - PCIe (1x) |
---|
9 | J28 - XMOD J28 for CPLD,FMC JTAG and Firmware ID over UART(need CPLD Firmware 7 or newer) , XMOD LED D4 Red used for status information |
| I | J30 - PJTAG |
---|
10 | FPGA Done LED (location varies slightly depending on different module series ) |
| J | J5 - FMC HPC |
---|
11 | J20 - ATX Power Connector J20 (Main 12V and 5V Power supply), recommended power supply connector |
| K | J24 - CAN |
---|
12 | D1 - SFP LED D1 Red (Usage: status/user) |
| L | J8 - USB 3.0 (2x) Enclosure |
---|
13 | D8 - SFP LED D8 Green (Usage: status/user) |
| M | J27 - SD |
---|
14 | D9 - SFP LED D9 Red (Usage: status/user) |
| N | J14 - SFP (2x) |
---|
15 | D10 - SFP LED D10 Green (Usage: status/user) |
| O | J7 - USB 3.0 (2x), ETH (1x) |
---|
16 | J7 - ETH LED Yellow (Usage: status) |
| P | J13 - Displayport (1x) |
---|
17 | J7 - ETH LED Green/Orange (Usage: status) |
| Q | P2 - PMOD 3.3V FPG IOs || Bottom side: J16 - microSD |
---|
18 | LEDs D4 - LED Green (Usage: status/user) and || D5 - LED Red (Usage: status/user) |
|
|
|
---|