Page History

...

The Trenz Electronic TE0716 is a commercial-grade* SoM (System on Module) based on Xilinx Zynq-7000 SoC XC7Z020*, with 1GB of DDR3L-1600 SDRAM*, 32MB of SPI flash memory, 10x 12-Bit Low Power SAR ADCs, 512Kb Serial EEPROM, Gigabit Ethernet PHY transceiver, an USB PHY transceiver, a single chip USB 2.0 to UART/JTAG Interface (Xilinx License included), and powerful switching-mode power supplies for all on-board voltages. A large number of configurable I/Os are provided via rugged high-speed board-to-board connectors.

Refer to http://trenz.org/te0716-info for the current online version of this manual and other available documentation.

Notes: * standard values but depends on assembly version. Additional assembly options are available for cost or performance optimization upon request.

...

• SoC/FPGA
  
  • Package: CLG484
  • Device: Xilinx Z-7020
  • Speed: -1 *
  • Temperature: C grade *.
• RAM/Storage
  • Low Power DDR3 SDRAM on PS
    • Data width: 32bit
    • Size: def. 1GB *
    • Speed: 1600 Mbps **
  • QSPI boot Flash
    • Data width: 4bit
    • size: 32MB *
  • MAC address serial EEPROM with EUI-48™ node identity (Microchip 24AA025E48).
  • 512Kb user MAC address serial EEPROM.
• On Board
  
  • 10x 12-Bit Low Power SAR ADCs up to 2 MSPS (NCD98011).
  • Low Power Oscillators.
  • Gigabit Ethernet PHY transceiver (Marvell Alaska 88E1512).
  • High-Speed USB 2.0 ULPI transceiver with full OTG support (Microchip USB3320C).
  • Single chip High-Speed USB 2.0 to UART/JTAG Interface (Xilinx License included) (FTDI FT2232H).
  • 2xUser RGB 2x User RGB LEDs (Green), LED FPGA "Done" (Green).
  • 2 x Tactile 2x Tactile Switches (User), 1 x Tactile Switche (Reset).
• Interface
  • 120 x 120x HR PL I/Os (3 banks).
  • 2x PS MIOs (shared with UART TX/RX ZYNQ-FTDI).
  • 1 Gbps RGMII Ethernet interface.
  • High Speed USB 2.0 ULPI with full OTG support.
  • High Speed USB 2.0 to UART/JTAG interface, including microUSB-B connector.
  • microSD™
  • JTAG

...