Page History

...

TEBF0808

TE0790-02

(with green dot)

TE0790-02L

Note: with CPLD Firmware REV06 or newer, S4.4 can be set to OFF, to save power, if Starter Kit is powered off with Power Button.

- Section is currently not complete -

...

Identification: FANs do not work, some LEDs blinking.

LED description (need CPLD Firmware REV06 or newer):

BLUE Power LED on enclosure
Status/ User	Blink Sequence	Comment
Power	******** (slow blink)	Indicate board is powered off.
RGPIO controlled	User Defined	RGPIO 14 and 15, if RGPIO is active.
MIO40	User Defined	MIO40, if RGPIO is deactivated

...

Identification: FANs do work, LEDs blinking states change.

LED description(need CPLD Firmware REV06 or newer):

BLUE Power LED on enclosure
Status/ User	Blink Sequence	Comment
Power	******** (slow blink)	Indicate board is powered off.
RGPIO controlled	User Defined	RGPIO 14 and 15, if RGPIO is active.
MIO40	User Defined	MIO40, if RGPIO is deactivated

Red HD LED on enclosure
Status/ User	Blink Sequence	Comment
PS_INIT_B	********	Indicates the PS is not initialized after a power-on reset (POR).
PS_ERROR_OUT	*****ooo	The PS_ERROR_OUT signal is asserted for accidental loss of power, an error, or an exception in the PMU.
ERR_STAT	****oooo	The PS_ERROR_STATUS indicates a secure lockdown state. Alternatively, it can be used by the PMU firmware to indicate system status.
RGPIO controlled	User Defined	RGPIO 16 and 17, if RGPIO is active
SC0	User Defined	SC0 (PL IO), if RGPIO is deactivated

Most LEDs are CPLD Firmware dependents, see TEBF0808 Master CPLD and TEBF0808 Slave CPLD

...

Versions Compared