Page History
...
JTAGENB set CPLD into the Chain for Firmware update. In normal mode every FMC JTAG will be set into the chain, when his FMCx_PRSNT is detected.
Power
ENNEN_12V and EN_VCCINT are enabled on power up. All other powers power enables will be enabled set, if , PG_12V and PG_FPD are valid.
...
SD Boot, when SC_SW1 is one else SQPI Boot.
S4-3 | S4-5 | Description |
---|---|---|
OFF | OFF | SD1 Boot |
OFF | ON | PJTAG0 |
ON | OFF | QSPI32 |
ON | ON | JTAG |
FANs
6 FMC FANs controlled by corresponding FMCx_PRSNT signals to enable FANs only for active FMC slots.
...
Date | Document Revision | CPLD Firmware Revision | Supported PCB Revision | Authors | Description | ||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
2017.05.2324 |
| REV02 | REV01 |
| REV02 working in processRevision 02 finished | ||||||||||||||
2016-10-16 |
v.22 | REV01 | REV01 |
| Revision 01 finished | ||||||||||||||
2016-04-11 |
v.1 | --- |
| Initial release | |||||||||||||||
All |
...
Overview
Content Tools