Versions Compared

Old Version 5

changes.mady.by.user John Hartfiel

Saved on

compared with

New Version 6

changes.mady.by.user John Hartfiel

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Connect MiniUSB cable to XMOD
  2. Set DIP Switch S1-2 to ON OFF position, see TE0706 TRM#4-bitDIP-switch
  3. Power ON the board
  4. Run "Lattice Diamond Programmer"

  5. Select "Create new project from JTAG chain" and press "OK"

Available CPLD Firmware

  • TE0820-REV01_REV02 CPLD - Firmware description with different Variants
    • QSPI / SD Boot Modi - Default delivered, QSPI or SD Boot Mode is selectable (Special FSBL for QSPI Programming with Boot Mode /= JTAG will be provided for Vivado 2017.4 Reference Design and newer).
    • QSPI / JTAG Boot Modi - Use QSPI  or JTAG Boot Mode is selectable
    • JTAG / SD Boot Modi - SD or JTAG Boot Mode is selectable 
    • JTAG / QSPI / SD Boot Modi - QSPI, SD or JTAG Boot Mode is selectable (CPLD Pin 23 (NOSEQ) is used as second Boot Mode pin to select JTAG Boot Mode). Attention: This need 7 Series 4x5 Carrier CPLD Firmware update.