Page History

...

1. Prepare HW like described on section Programming
2. Connect UART USB (most cases same as JTAG)
3. Select SD Card as Boot Mode (or QSPI depending on programming option)
   Note: See TRM of the Carrier, which is used.
4. Power On PCB
   Note: 1. Zynq Boot ROM loads FSBL from SD into OCM, 2. FSBL loads U-boot from SD into DDR, 3. U-boot load Linux from SD into DDR

...

1. Open Serial Console (e.g. putty)
   
   1. Speed: 115200
   2. COM Port: Win OS, see device manager, Linux OS see  dmesg |grep tty  (UART is *USB1)
2. Linux Console:
   Note: Wait until Linux boot finished For Linux Login use:
   
   1. User Name: root
   2. Password: root
3. You can use Linux shell now.
   1. I2C 0 Bus type: i2cdetect -y -r 0
   2. ETH0 works with udhcpc

Vivado HW Manager

• CAN Standby control
• module LED control
• TEB0724 LED control
• TEB0724 Button monitoring
• PMIC GPIO monitoring
• PHY 125MHz Monitoring
  

Image Addedtodo

System Design - Vivado

<!--
Description of Block Design, Constrains...
BD Pictures from Export...
  -->

Block Design

todoImage Added

PS Interfaces

...

Type	Note
DDR
QSPI	MIO
ETH0	MIO
SD0	MIO
UART1	MIO
I2C1	MIO
CAN0	EMIO
GPIO	MIO
TTC0..1	EMIO
WDT	EMIO

Constrains

Basic module constrains

...