set “EEPROM” switch to EEPROM connection disabled (EEPROM disconnected from USB microcontroller) (1);
turn on the TE USB FX2 module;
if the TE0300 module is used, the S2 switch must be turned set to on (RUN);
if the TE0320 module is used, the S1D switch must be turned on set to off (RUN);
connect the module to the host computer through the USB interface;
Open "Device Manager" using one of this two procedure:
Start\Control Panel\System and Security\System\Device Manger
write devmgmt.msc in the line “Search programs and files”
to go directly to the Device Manager
wait until the operating system detects new hardware; module enumerates in recovery mode
Scroll pdf title
title
If the TE USB FX2 module enumerate as Cypress device you should check if the Cypress Generic USB device driver is already installed; if it is already installed the procedure ends here.