Versions Compared

Old Version 6

changes.mady.by.user Sergio Pavesi

Saved on

compared with

New Version 7

changes.mady.by.user Sergio Pavesi

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Open CyControl

Note

The firmware actually changes (it runs on USB FX2 microcontroller's RAM) only when

  • you reset the TE USB FX2 module;
  • you power off and power on the TE USB FX2 module;
  • you write the USB FX2 microcontroller's RAM (but the new firmware is lost if the TE USB FX2 module goes under reset or power off/on cycle).

...

Scroll pdf title
titleCyControl starts
Recovery boot
Update/normal boot

RAM programming

To program the RAM you should click "Program FX2" and select "RAM". Then you should select the .iic file to download.

...

Note

The RAM can be programmed even if EEPROM switch is disabled.

If you don't also write the IIC EEPROM  ("Program>FX2 64KB EEPROM"), the new firmware is lost if the TE USB FX2 module goes under reset or power off/on cycle.

EEPROM programming

To program the Large (64K) EEPROM you should click "Program FX2" and select "64KB EEPROM". Then you should select the .iic file to download.

...