Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

NameNote
NRST 
NRST_IN 

Boot Modes

By default the TE-0729 supports QSPI-Flash-Memory, JTAG and SD-Card (if available on base board) boot modesTE0729 supports primary boot from

  • JTAG
  • SPI Flash
  • SD Card

Boot from on-board eMMC is also supported as secondary boot (FSBL must be loaded from SPI Flash).

The boot modes are controlled by the Pins 'BOOT1' and 'BOOT2' on the board to board (B2B) connector.

Pin-StateBOOTMODE1BOOTMODE1 /

BOOTMODE2boot Boot mode
LOW / LOW 
LOW / HIGH 
HIGH / LOW 
HIGH / HIGH 

JTAG

JTAG access to the Xilinx Zynq-7000 device is provided by connector J2.

...

PeripheralICDesignatorPSMIONotes
EEPROM I2C24AA025E48T-I/OTU8I2C0MIO10, MIO11MAC1-AdressMAC Address
EEPROM I2C24AA025E48T-I/OTU9I2C0MIO10, MIO11MAC2-AdressMAC Address
EEPROM I2C24AA025E48T-I/OTU20I2C0MIO10, MIO11MAC3-AdressMAC Address
RTCISL12020MIRZU22I2C0MIO10, MIO11Temperature compensated real time clock
RTC InterruptISL12020MIRZU22GPIOMIO46Real Time Clock Interrupt
SPI FlashS25FL256SAGBHI20U13QSPI0MIO1..MIO6 
Ethernet0 10/100/1000 Mbps PHY88E1512-A0-NNP2I000U3ETH0MIO16...MIO27 
Ethernet0 10/100/1000 Mbps PHY Reset  GPIOMIO51 
Ethernet1 10/100 Mbps PHYKSZ8081MLXCAU17-(EMIO) 
Ethernet1 10/100 Mbps PHY Reset  -(EMIO) 
Ethernet2 10/100 Mbps PHYKSZ8081MLXCAU19-(EMIO) 
Ethernet2 10/100 Mbps PHY Reset  -(EMIO) 
USBUSB3320C-EZKU11USB0MIO28...MIO39 
USB Reset  GPIOMIO49 
 e-MMC (embedded e-MMC)MTFC4GMVEA-4M IT  U5SDIO0MIO40...MIO45depending on state of pin MIO48 'SEL_SD'

...