Page History
...
Issues | Description | Workaround | To be fixed version | |||
---|---|---|---|---|---|---|
PCB REV01 only: IBERT no CLK | PCB REV01 SI5338 is not preprogrammed and SI programming over MCS is disabled by default design | Open Blockdesign and change IP "xlconstant_mcs_on_off" value from one to zero | --- | --- | --- | --- |
Requirements
Software
HTML |
---|
<!-- Add needed external Software --> |
...
- Prepare HW like described on section Programming 70156396
- Connect UART USB (most cases same as JTAG)
- Power on PCB
Note: FPGA Loads Bitfile from Flash,MCS Firmware configure SI5338 and starts IBERT.
Do not reboot, if Bitfile programming over JTAG is used as programming method.- On TE0841 SI5338 has default configuration and reprogramming of SI5338 is optional
- LED:
- D1 (green) OFF→ MCS SI configuration finished (System Reset is off)
...
Date | Document Revision | Authors | Description | ||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
|
|
| ||||||||||||||||||||||
v.5 | John Hartfiel |
| |||||||||||||||||||||||
v.4 | John Hartfiel |
| |||||||||||||||||||||||
2018-04-16 | v.1 |
|
| ||||||||||||||||||||||
All |
|
...
Overview
Content Tools