Page History

...

1. Place CR00140 on CRUVI carrier.
2. Make sure that JTAGEN pin on J9-57 is NOT driven low by the carrier.
3. Use TEI0004 ARROW USB Programmer2 and connect to J10, or connect signals: TCK, TDO, TMS, TDI, Ref. I/O-voltage (3.3V), GND to your quartus compatibel programmer.
4. Connect programmer via usb to your PC.
5. Power up carrier, so that +3.3V_D is powered by 3.3V.

General instructions

...

• Quartus Prime Software (Lite version sufficient, available for free here)
• Quartus Prime compatible JTAG programmer:
  
  • ARROW USB Programmer2 hardware is fully compatible with Quartus Programmer both on Windows and Linux platforms. One time installation of Arrow USB Programmer2 is required. Arrrow USB Programmer2 or newer setup files are available on our download page: ARROW USB Programmer2.
  • Any other JTAG Programmer compatible with Quartus Prime.
• Firmware suitable for device.

Firmware Update - General Procedure

Important:

• Connect only one JTAG device to host PC.
• Close all other JTAG programs, like Xilinx tools (on WinOS check hw_server.exe is terminated).

Procedure:

...

...