...
| Scroll pdf title |
|---|
|
 Image Added Image Removed
|
SPI signals on the TE0630 are listed and described in the table below.
...
| Scroll pdf title |
|---|
| title | SPI pin-out summary; SPI signal details (bank 2). |
|---|
|
nameFPGA ball | FPGA pin | J5 pin | SPI_Q | IO_L03N_2 | no | SPI_D | | IO_L16N_2 | no | SPI_/C | | IO_L26N_2 | no | SPI_/S | | IO_L01P_2 | no |
|
| Warning |
|---|
SPI pins on B2B connector J5 cannot be used as GPIOs (general purpose I/Os).
|
The SPI bus can be used during configuration and operation in a plurality of ways as summarized respectively in Table A (SPI bus for configuration) and Table B (SPI bus for operation).
...
| Scroll pdf title |
|---|
| title | Table A: SPI bus modes for configuration. |
|---|
|
description | usage | EZ-USB FX2LP | FPGA | B2B J5 | serial Flash |
|---|
EZ-USB â-º Flash | OpenFUT
API | master | off
(S3 = FX2PON,
FX2_PS_EN = 0) | deselected | slave | FPGA â—„ Flash | OpenFUT
API | inactive
SPI_* = Z | master
(SPI_/S = 1) | deselected | slave | B2B J5 â-º Flash
| custom
| inactive
SPI_* = Z
| off
(S3 = FX2PON, | FX2_PS_EN = 0)master
(
|
SPI
...
slave
The PROM file (containing the FPGA configuration bitstream) can be written to the SPI serial Flash memory (slave) also through the SPI pins of B2B connector J5 (attached device set to master mode). In this case, the FPGA shall be turned off or three-stated to release its shared SPI pins and the USB FX2 microcontroller shall three-state (Z = high impedance) its shared SPI pins.
SPI bus for operation
A plurality of usage combinations of the SPI bus during operation is made available to the user as suggested in Table B below.
| Scroll pdf title |
|---|
| title | Table B: SPI bus modes for operation. |
|---|
|
description | usage | EZ-USB FX2LP | FPGA | B2B J5 | serial Flash | EZ-USB â—„â-º Flash | custom | master | off
(S3 = FX2PON,
FX2_PS_EN = 0) | deselected | slave | FPGA â—„â-º Flash | custom | inactive
SPI_* = Z | master
(SPI_/S = 1) | deselected | slave | B2B J5 â—„â-º Flash
| custom
| inactive
SPI_* = Z
| off
(S3 = FX2PON,
FX2_PS_EN = 0)
| master
(SPI_/S = 0)
| slave
| EZ-USB â—„â-º B2B J5
| custom
| master
SPI_/S = 1off
(S3 = FX2PON,
FX2_PS_EN = 0)
| slave
| deselected | EZ-USB â—„â-º B2B J5
| custom
| slave |
SPI_/C = Zoff
(S3 = FX2PON,
FX2_PS_EN = 0)
| master
(SPI_/S = 1)
| deselected |
|
| Warning |
|---|
| Other combinations of master and slave units are neither supported nor recommended. |