Page History

Products Affected

This change affects all Trenz Electronic TE0712 SoMs of revision 02: TE0712-02-*.

...

Impact: None. Minor changes in electrical characteristics.

#4 Added power monitors STM6710LWB6F (U10, U11). Changed system controller pin 25 from 3.3V to signal "PG_ALL" from new power monitors.

...

Added testpoint TP25 at signal "PG_ALL".

Type: Schematic Change

Reason: Power Handling Improvement

Impact: None. Voltage supply monitoring leads to resetsVoltages are monitored and if out of range reset is triggered.

#5 Added diode D3 between signals "INIT" and "PROG_B".

...

• New CBP version (4.6) is used which leads to MultiSynth parameter changes.
• Enable optional FPGA Fabric clock CLK0 100 MHz with LVDS.
• Enable clock CLK1 50 MHz with two single ended (Port A and B) CMOS in phase clocks instead of one (Port A) used for ETH PHY syncronisation.

Type: Schematic Firmware Change

Reason: Unify Improved PLL settings.

Impact: NoneTwo additional clocks are availabe. Settings are saved in NVM. Minor changes in electrical characteristics.

...