Page History

The module has two B2B (board-to-board) receptacle connectors (J4 and J5) for a total of 160 contacts. Figure 6 The figure below shows B2B connectors location on board; USB connector is located on the top side and is shown to define module position.
Figure 6:

TE0630 uses high-density shockproof connectors shown in Figure 7. the figure below.

Connector part numbers are listed in Table 4.
Figure 7: Module connectorthe table below.

...

The on-board receptacles mate with their corresponding headers on the carrier board shown in Figure 8. the figure below.

Ordering numbers of mating connectors are listed in Table 5.
Figure 8: Mating (carrier board) connectorthe table below.

Table 5: Carrier board headers part numbers.
Figure 9  The figure below shows the definition of stacking height featured by the combination of the TE0630 receptacle with its corresponding header.
Figure 9:

The stacking height of the TE0630 B2B connectors is 7 (seven) mm. The stacking height does not include the solder paste thickness.