JTAG
...
signals are available at:JTAG signal lines are also available at
- gender-inverted standard 6-pin JTAG header connector J2;
- B2B connector JM4.
...
JTAG Connector J2
The offset holes of header J2 allow a removable press fit of standard 0.100 inch header pins to connect flying leads without any soldering necessary.
JTAG signals are available on the gender-inverted standard 6-pin JTAG header connector J2 as shown in Figure 24.
...
dedicated header J2 through a JTAG programmer with flying leads as described in the table below.
Scroll pdf title |
---|
|
Image Added |
VREF GND TCK TDO TDI TMS |
|
Figure 24: JTAG connector J2.
To connect your computer to JTAG connector J2, you typically need
- a JTAG cable with standard 6-pin JTAG female header;
- a 2.54 mm pitch 1 × 6 pin gender changer header.
Some examples of JTAG cable set are listed in Table 4the table below.
Scroll pdf title |
---|
title | Some examples of JTAG cable set. |
---|
|
JTAG cable | flying leads | software | gender changer |
---|
Xilinx Platform Cable USB | included | Xilinx iMPACT | 1 × 6 pin | Digilent XUP USB-JTAG Programming Cable | XUP Fly Wire Assembly | Xilinx iMPACT | 1 × 6 pin | Digilent JTAG-USB Full Speed Module | included |
|
...
Xilinx iMPACT Digilent Adept 2.0 | 1 × 6 pin |
|
...
| JTAG HS1 Programming Cable | not needed | Xilinx iMPACT Digilent Adept 2.0 | not needed | JTAG HS1 Programming Cable | not needed | Xilinx iMPACT Digilent Adept 2.0 | not needed |
|
Figure A below Table 4: some examples of JTAG cable set.
Figure 25 shows a standard 6-pin JTAG female header, in this case flying leads, with a gender changer header.
Figure 26 B below shows how a JTAG cable, in this case a Xilinx Platform Cable USB with flying leads and gender changer, is connected to a TE0320.
...
Image Removed
...
Image Removed
Scroll pdf title |
---|
|
Image Added | Image Added | Figure A |
|
...
: standard 6-pin JTAG female header with gender changer. | Figure |
|
...
B: sample JTAG cable connection |
|
...
Figure 27 The figure below shows a recommended set-up for TE0320 configuration and operation. The USB cable provides for power supply and data communication channel. The JTAG is ideal for quick configuration and effective debugging.Image Removed
Figure 27: recommended TE0320 set-up
Scroll pdf title |
---|
title | Recommended development set-up for TE0320. |
---|
|
Image Added |
JTAG lines at B2B connector JM4
JTAG signal lines are also available at B2B connector JM4 (pins 74, 76, 78 and 80). See the corresponding pin-out table for additional information on these signals.