Tip |
---|
To see the device status you should open "Device Manager" using one of this two procedure: - Start\Control Panel\System and Security\System\Device Manger
- write devmgmt.msc in the line “Search programs and files” to go directly to the Device Manager
|
Most users don't need this driver, this driver is used only for initial USB FX2 microcontroller programming, which was already done for all supplied TE modules.
...
- set “EEPROM” switch to EEPROM connection disabled (EEPROM disconnected from USB microcontroller) (1);
- turn on the TE USB FX2 module;
- if the TE0300 module is used, the S2 switch must be set to on (RUN);
- if the TE0320 module is used, the S1D switch must be set to off (RUN);
- connect the module to the host computer through the USB interface;
Open "Device Manager" using one of this two procedure:
to go directly to the Device Managerwait until the operating system detects new hardware
and starts the hardware assistant;; module enumerates in recovery mode
Scroll pdf title |
---|
title | If the TE USB FX2 module enumerate as Cypress device you should check if the Cypress Generic USB device driver is already installed; if it is already installed the procedure ends here. |
---|
|
|
- you could set “EEPROM” switch to enable EEPROM connection (EEPROM connected to USB FX2 microcontroller) (1);
- starts the hardware assistant;
answer the hardware assistant questions
as shown in the following images (images to add: you should select the driver for your Operating System;
The driver package contains many folders. During installation, the user shall specify the folder according to 32 (x86)/ 64 (x64) bit distinction and the following table.
Scroll pdf title |
---|
title | Device driver folder selection |
---|
|
| | |
---|
2000, 32 bit
| MS-Windows-2000\x86 | not available |
---|
XP, 32 bit | MS-Windows-XP\x86 | not available |
---|
XP, 64 bit | MS-Windows-XP\x64 | not available |
---|
Vista, 32 bit
| MS-Windows-Vista+7\x86 | not available |
---|
Vista, 64 bit | MS-Windows-Vista+7\x64 | not available |
---|
7, 32 bit
| MS-Windows-Vista+7\x86 | available (an equivalent driver) |
---|
7, 64 bit
| MS-Windows-Vista+7\x64 | available (an equivalent driver) |
---|
8, 32 bit
| MS-Windows-Vista+7\x86 | available (an equivalent driver) |
---|
8, 64 bit | MS-Windows-Vista+7\x64 | available (an equivalent driver) |
---|
|
- Check that, in the “Device Manager” under “USB-Controller”, the “Cypress Generic USB Device” has been added.
(1) Refer to your module manual for switch location.