Page History

TE0630 Configuration Switches: settings for USB Firmware, FPGA bitstream programming and Power Supply. 

On-board 4xDIP switch S1 used for system and user settings.

System setting 

Slide Switch S1A

Switch S1A is used to connect the USB controller to the IIC serial EEPROM:

...

TE USB FX2 module is powered on when S1A is turned off: this will force the USB controller to provide its default (Cypress) vendor ID and device ID.

Slide Switch S1B

Switch S1B is used to control DC-DC converters:

• when switch is "OFF", converters are controlled by the USB controller;
• when switch is "ON", converters are enabled regardless of USB controller actions. At start-up, the USB controller switches off 1.2V, 1.5V and 2.5V power rails and starts up the module in low-power mode. After enumeration, the USB controller firmware switches the 1.2V, 1.5V and 2.5V power rails on, if enough current is available from the USB bus.

User Settings

Switches S1C and S1D can be used as user switches. Switches are active-low. Pull-up resistors should be defined in user constrains file (UCF) to use this switches in FPGA design. See the table below for details

...