...
After this, even if refresh operation appears correct and no errors are reported, you should check the SDK Workspace references to TE EDK IP core drivers.
To open the SDK workspace reference repositories you should click "Xilinx Tools" > "Repositories".
Scroll Title | ||
---|---|---|
| ||
A new pop-up windows will appear. You should remove the wrong reference clicking/selecting "B:\GIT\TE03XX-Reference-Designs\TE-EDK-IP" and clicking "Remove" button.
Scroll Title | ||
---|---|---|
| ||
You should add the correct reference to TE EDK IP cores drivers.
Click the "New..." button and a pop-up "Select folder" will appear.
You should select the desired folder: "TE-EDK-IP" or "TE-EDK-IP\MyProcessorIPlib" should be both correct
Note |
---|
It is better if you do not alter folder nesting because double nesting of folders is a Xilinx XPS requirements (even if it is not an SDK requirement). |
Then click "OK". A new SDK reference for IP Core drivers should appear.
Scroll Title | ||
---|---|---|
| ||
Then click "OK" button. The pop-up "Preferences" will close and you should wait until the following message appears.
Scroll Title | ||
---|---|---|
| ||
You should also You should check the "Application Project" "demo" references.
Click/select "demo" in "Project Explorer", then click "Project">"Properties".
Scroll Title | ||
---|---|---|
| ||
The pop-up "Properties for demo" will open on "Resource"
Scroll Title | ||
---|---|---|
| ||
You should click /select "Project References". A new window wil appear on the same pop-up.
Scroll Title | ||
---|---|---|
| ||
You shoul also check () "reference-TE0300_hw_platform".
Scroll Title | ||
---|---|---|
| ||
After this you should click "OK". You should wait until this mesagge will appear.
Scroll Title | ||
---|---|---|
| ||
You should also check the "Board Support Package Project" references.
Change rs232 to debug_module
You should generate a new link script.
STDIO connection of RUN and DEBUG: JTAG UART
...
Click/select "standalone_bsp_0" in "Project Explorer", then click "Project">"Properties".
Scroll Title | ||
---|---|---|
| ||
A new pop-up window "Properties for standalone_bsp_0" will appear.
Scroll Title | ||
---|---|---|
| ||
In this case the bsp setting is correct. Only "reference-te0300_hw_platform" shoul be checked ().
Click "OK" and the pop-up will dissapear.
Now, you should select if you desire to debug on a real UART (rs232) or a simulated UART on JTAG (debug_module).
You should click/select "standalone_bsp_0" in "project Explorer", then you should click "Xilinx Tools" > "Board Support Package Settings".
Scroll Title | ||
---|---|---|
| ||
A new pop-up will appear "Board Support Package Settings".
Scroll Title | ||
---|---|---|
| ||
After this, you should click "standalone" and set "stdin" and "stdout" to "rs232" or "debug_module":