...
You should select the desired folder.: "TE-EDK-IP" or "TE-EDK-IP\MyProcessorIPlib" should be both correct
Note |
---|
It is better if you do |
Warning |
You should not alter folder nesting or select MyProcessorIPLib because double nesting of folders is a Xilinx XPS and SDK requirementsrequirements (even if it is not an SDK requirement). |
Then click "OK". A new SDK reference for IP Core drivers should appear.
Scroll Title | ||
---|---|---|
| ||
Then click "OK" button. The pop-up "Preferences" will close and you should wait until the following message appears.
Scroll Title | ||
---|---|---|
| ||
You should also check the "Application Project" "demo" references.
Click/select "demo" in "Project Explorer", then click "Project">"Properties".
Scroll Title | ||
---|---|---|
| ||
The pop-up "Properties for demo" will open on "Resource"
Scroll Title | ||
---|---|---|
| ||
You should click /select "Project References". A new window wil appear on the same pop-up.
Scroll Title | ||
---|---|---|
| ||
You shoul also check () "reference-TE0300_hw_platform".
Scroll Title | ||
---|---|---|
| ||
After this you should click "OK". You should wait until this mesagge will appear.
Scroll Title | ||
---|---|---|
| ||
You should also check the "Board Support Package Project" references.
Change rs232 to debug_module
You should generate a new link script.
STDIO connection of RUN and DEBUG: JTAG UART
...
Click/select "standalone_bsp_0" in "Project Explorer", then click "Project">"Properties".
Scroll Title | ||
---|---|---|
| ||
A new pop-up window "Properties for standalone_bsp_0" will appear.
Scroll Title | ||
---|---|---|
| ||
In this case the bsp setting is correct. Only "reference-te0300_hw_platform" shoul be checked ().
Click "OK" and the pop-up will dissapear.
Now, you should select if you desire to debug on a real UART (rs232) or a simulated UART on JTAG (debug_module).
You should click/select "standalone_bsp_0" in "project Explorer", then you should click "Xilinx Tools" > "Board Support Package Settings".
Scroll Title | ||
---|---|---|
| ||
A new pop-up will appear "Board Support Package Settings".
Scroll Title | ||
---|---|---|
| ||
After this, you should click "standalone" and set "stdin" and "stdout" to "rs232" or "debug_module":