Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

If the USB microcontroller (Cypress EZ-ESB FX2) TE USB FX2 driver is not installed on the host computer, then the easiest way to do it, is the following:
  • disconnect the module if it connected or leave the module unconnected;
  • turn off the TE USB FX2 module;
  • set “EEPROM” switch to enable to  EEPROM connection enabled (EEPROM connected to disconnected from USB FX2 microcontroller) (1);
  • turn on the TE USB FX2 module;
  • connect the module to the host computer through the USB interface;
  • wait until the operating system detects new hardware and starts the hardware assistant;
  • answer the hardware assistant questions as shown in the following document;
  • Check that, in the “Device Manager” under “Trenz Electronic USB devices”, the “Trenz Electronic USB FX2” has been added.

(1) Refer to your module manual for switch location.