Page History
...
Note. DNP: Do Not Populate aka Do Not Solder the Component associated to DNP label.
Figure 33: Dip switch S1B (angle view)switch S1[A:B aka 1:4]. The switch S1B is the one with label 2.
Figure 34: Dip switch S1B schematic.
Figure 35: When Dip switch S1B = FX2 PON, signal PS_EN is set to signal FX2_PS_EN driven by the EZ-USB FX2LP USB FX2 microcontroller under user control.
...
When Dip switch S1B is in the left position ( = FX2 PON : power rails conditionally on depending on signal FX2_PS_EN), signal PS_EN is set to signal FX2_PS_EN (PS_EN = FX2_PS_EN) driven by the EZ-USB FX2LP USB FX2 microcontroller under user control (IOD and OED of fw.c).
Figure 38: S1B on position FX2 PON (PS_EN = FX2_PS_EN = 1 or 0 ).
...
Full power operation (PS_EN = 1): when Dip switch S1B is in the right position (PON = power rails unconditionally on), signal PS_EN is set to power rail 3.3V. Thus power rails 1.2 V, 1.5 V and 2.5 V are unconditionally enabled.
Figure 39: S1B on position PON (PS_EN ≠ FX2_PS_EN = x; PS_EN = high ).
...
Overview
Content Tools