Page History

To configure a TE USB FX2 module via USB bus, there are different procedures to follow according to module status and purpose of use.

See OpenFutNet, Firmware Tool Tools Comparison ane and recovery boot.

For instance, a full quality control test already performed at Trenz Electronic laboratory premises requires all the following steps to be performed:

1. Cypress USB generic device driver installation;
2. USB FX2 microcontroller large EEPROM programming;
3. specific USB device driver installation;

4. an *.iic file generation/download;

5. a firmware upgrade tool (Cypress tools: CyConsole or CyControlCenter TE tools: OpenFut, OpenFutNet or FX2EEPROMProgrammer) utilization.

6. reference bitstream file written on SPI Flash  ?????custom bitstream file written on SPI Flash ?????

   Scroll pdf title
   title Configuration steps via USB bus according to module status and purpose of use.
   step first development cycle following development cycles EEPROM recovery (boot recovery) quality control (lab test) (1)     ● ● (2)     ● ● (3) ●     ● (4) ● ●   ● (5) ● ●   ● (6) ● ●   ● (7)   ●   ● (7) custom bitstream file written on SPI Flash ????? is obviously not performed during quality control.