Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Scroll pdf title
titleRight click the "Boundary Scan" to initialize the chain and select "Initialize Chain"
Image Added
  • An "Assign New Configuration File" dialog window should pop up automatically. You can now select the file corresponding to your design. In the following example, we will show how to select the micromodule reference design "blinking.bit" in the "TE0300" folder. Do not forget to select the "Enable Programming of SPI Flash Device Attached to this FPGA" option in the same window.
Scroll pdf title
titleAn "Assign New Configuration File" dialog window should pop up automatically.
Image RemovedImage Added
  • An "Add PROM File" dialog window should pop up automatically. You can now select the file corresponding to your design. In the following example, we will show how to select the micromodule reference design "blinking.mcs" in the "TE0300" folder.
Scroll pdf title
titleAn "Add PROM File" dialog window should pop up automatically.
Image Added
  • Select now the SPI Flash corresponding to the one present on the module (STMicroelectronics M25P32 in the example, a 32 Mbit (4M x 8) Serial Flash memory).
Scroll pdf title
titleSelect now the SPI Flash corresponding to the one present on the modul
Image Added
  • iMPACT should now look like this.
Scroll pdf title
titleiMPACT should now look like this
Image Added

 


Right click the "Flash" device and select the "Program" operation.

In the "Device Programming Properties" window, just leave the default settings and press the "OK" button.

iMPACT will first erase the memory

and then write it.

After successful programming, you should read the message "Program Succeeded" popping up for a few seconds in the "Boundary Scan" panel.



Switch S3 back to the "FX PON" position. In case you uploaded the reference design, you should see the on-board led blinking at 0.5 Hz.
For further information about indirect (SPI over JTAG) in-system programming of SPI Flash memories, please see Xilinx Application Note XAPP974 "Indirect Programming of SPI Serial Flash PROMs with Spartan-3A FPGAs".

...