...
If the USB microcontroller (Cypress EZ-ESB FX2) TE USB FX2 driver is not installed on the host computer, then the easiest way to do it, is the following:
- disconnect the TE USB FX2 module if it connected or leave the module unconnected;
- turn off the TE USB FX2 module;
- set “EEPROM” switch to EEPROM connection enabled (EEPROM disconnected from USB microcontroller) (1);
- turn on the TE USB FX2 module;
- if the TE0300 module is used, the S2 switch must be turned on (RUN);
- if the TE0320 module is used, the S1D switch must be turned on (RUN);
- connect (aka plug in, aka attach)the TE USB FX2 module to the host computer through the USB interface;