...
Scroll pdf title | ||||||||
---|---|---|---|---|---|---|---|---|
| ||||||||
Table from EZ-USB(R) Technical Reference Manual (EZ-USB_TRM.pdf)
|
Signal PS_EN enables (1) or disables (0) power rails 1.2 V, 1.5 V and 2.5 V.
Scroll pdf title | ||
---|---|---|
| ||
Power-rail 3.3V is not controlled by signal PS_EN and is unconditionally enabled.
Scroll pdf title | ||
---|---|---|
| ||
According to the corresponding assembly option, power rail VCCCIO0 can depend or not on the power rail 2.5V.
VCCIO0 voltage can be configured in 3 ways:
(1) See Spartan-6 documentation fo VCCIO power range.
Scroll pdf title | ||
---|---|---|
| ||
Warning |
---|
Others options of VCCIO0 power supply are not supported and can damage the FPGA! |
See the figure below to locate R102 and R103 on PCB.
Scroll pdf title | ||
---|---|---|
| ||
...
Full power operation (PS_EN = 1): when Dip switch S1B is in the right position (PON = power rails unconditionally on), signal PS_EN is set to power rail 3.3V. Thus power rails 1.2 V, 1.5 V and 2.5 V are unconditionally enabled.
Scroll pdf title | ||
---|---|---|
| ||
|
The table below summarizes all switching options implied by Dip switch S1B and firmware signal FX2_PS_EN (under the standard assembly option).
Scroll pdf title | ||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||||||||||||
(1) R102 unpopulated / R103 populated (2) R102 populated / R103 unpopulated |