Page History

Table of Contents

General

• Unpack and handle the module in an ESD safe workplace only.
• Keep the module away from moisture and dust.
• Remove power completely before plugging the module onto or unplugging it from a carrier board.
• Do not apply any voltage to any pin, when the module is not powered.
• Do not apply any voltage to any I/O pin, when the Power Good signal of the module is not active.

Removal Instructions

Samtec LSHM connectors are shock-proof and vibrations resistant, and have therefore high mating forces. It is recommended to remove the module via the mounting holes. When mounted with distance holders, unscrew the screws on the baseboard bottom about 2 mm, then press the baseboard equally (e.g. on a desktop) to lift the module. Repeat this until the module is unplugged [see Video below]. If this is not possible, you have to use a soft lever.

...