Page History
...
It is possible to use same unmodified fs-boot.elf, u-boot-s.bin and image.ub as long as the hardware matches the requirements.
umin_linux
This Design is based on min_linux further reducing the peripherals and functions, debug : Debug and GPIO are removed. This design does fit into any Xilinx 7 series FPGA including A15T. On A15T device the design takes almost all logic resources, adding one more AXI peripheral would most likey likely go over 100% utilization. It is provided just show the utilization of the bare-minimal Microblaze-MMU system capable to run full Linux.
| FPGA | Slice used % | FF used % |
|---|---|---|
| A15T | 98% | |
| A35T | 49% | |
| A50T | ||
| A75T | ||
| A100T | ||
| A200T |
min_linux_eth
This Design is based on min_linux, adding AXI_Ethernetlite IP Core.
| IP Core | Base address | Interrupt | Board Part Interface | Notes |
|---|---|---|---|---|
| AXI_Ethernetlite | 0x40E0_0000 | 3 | sys_ethernet | on TE0710 is connectd to MII, on TE0712 ist connected with the core "MII to RMII" to RMII |
TE0710 uses MII Interface
TE0712 uses RMII Interface
Overview
Content Tools