Page History
...
There are one 4-bit DIP-witches S1 present on the TEBA0841 board to configure options and set parameters. The following table describes the of the particular switches:
| DIP-switch S1 | usage | Default | Signal Schematic Name | Connected to | Notes | Note | ||
|---|---|---|---|---|---|---|---|---|
| S1-1 | OFF module FPGA access | OFF(GND)S1A | BOOTMODE | JB1-90 | The functionalities of all DIP-switches is dependent on the mounted The DIP-switch sets control signals, which are usually routed to the So refer to the Wiki reference page of the SC CPLD firmware of the SoM. | |||
| S1B | EN1 | JB1-27 | ||||||
| S1C | MODE | JB1-31 | ||||||
| only used for module with CPLD | ||||||||
| S1-2 | OFF enabled ON disabled | OFF(VDD) | EN1 | JB1-27 | power enable, some modules can't disable power in this case it has normally the same effect like the reset pin | |||
| S1-3 | OFF QSPI Boot ON SD Boot | OFF(VDD) | MODE | JB1-31 | Boot mode selection, only for Zynq and ZynqMP devices, on FPGA modules not matter (always QSPI). JTAG is on all modes available | |||
| S1-4 | OFF enabled ON disabled | OFF(VDD) | NOSEQ | JB1-8 | power sequencing, only on some modules supported. Otherwise it's unused or can be reused by customer | S1D | NOSEQ | JB1-8
Table 12: DIP-switch S1, see also 4x5 Module Controller IOs
VCCIO Selection Jumper
On the TEBA0841 carrier board different VCCIO configurations can be selected by the jumper header J26, J27, J5 and J6.
...
Date | Revision | Contributors | Description | ||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
|
|
| ||||||||||||||||||||||||||
| 2018-07-13 | v.81 | John Hartfiel |
| ||||||||||||||||||||||||||
| 2018-07-10 | v.78 | John Hartfiel |
| ||||||||||||||||||||||||||
| v.75 | Ali Naseri, Jan Kumann |
|
...
Overview
Content Tools