Page History
...
Micro SD memory card connector J9 with detect switch is connected to the Zynq Soc PS MIO bank 500. See also section Default MIO Mapping.
FPGA IO Banks Pin Mapping
Bank | Zynq Pin | Name | Connected To |
---|---|---|---|
34 | G14 | PUDC | Jumper J14 |
35 | G15 | DSI_XA | System Controller CPLD, pin 16 |
35 | F15 | DSI_XB | System Controller CPLD, pin 17 |
Page break
GPIO to Header J8 Interface Mapping
GPIO Name | Zynq Pin | J8 Pin | GPIO Name | Zynq Pin | J8 Pin | |
---|---|---|---|---|---|---|
GPIO2 | K15 | 3 | GPIO15 | N13 | 10 | |
GPIO3 | J14 | 5 | GPIO16 | L13 | 36 | |
GPIO4 | H12 | 7 | GPIO17 | G11 | 11 | |
GPIO5 | N14 | 29 | GPIO18 | H11 | 12 | |
GPIO6 | R15 | 31 | GPIO19 | R12 | 35 | |
GPIO7 | L14 | 26 | GPIO20 | M14 | 38 | |
GPIO8 | L15 | 24 | GPIO21 | P15 | 40 | |
GPIO9 | J13 | 21 | GPIO22 | H13 | 15 | |
GPIO19 | H14 | 19 | GPIO23 | J11 | 16 | |
GPIO11 | J15 | 23 | GPIO24 | K11 | 18 | |
GPIO12 | M15 | 32 | GPIO25 | K13 | 22 | |
GPIO13 | R13 | 33 | GPIO26 | L12 | 37 | |
GPIO14 | M12 | 8 | GPIO27 | G12 | 13 |
FPGA IO Banks Pin Mapping
Bank | Zynq Pin | Name | Connected To |
---|---|---|---|
34 | G14 | PUDC | Jumper J14 |
35 | G15 | DSI_XA | System Controller CPLD, pin 16 |
35 | F15 | DSI_XB | System Controller CPLD, pin 17
Default MIO Mapping
Bank 500 MIOs
...
Normally TE0726 module is powered by micro-USB connector J1 VBUS pin, which voltage level is controlled by host according to the USB standards and should be 5V, so there is not much user can control here if using standard USB equipment. However if power.
Absolute Maximum Ratings
Parameter | Min | Max | Units | Notes |
---|---|---|---|---|
Power supply voltage | 2.7 | 5.5 | V | See AP2152SG-13 datasheet. Not applicable if TE0726 module is powered by micro-USB connector J1 as VBUS pin voltage level of 5V is controlled by the supplying side equipment. |
Storage temperature | -55 | +125 | °C | - |
Recommended Operating Conditions
Parameter | Min | Max | Units | Notes |
---|---|---|---|---|
Power supply voltage | 2.7 | 5.5 | V | See AP2152SG-13 datasheet. |
Operating temperature | 0 | 70 | °C | - |
Physical Dimensions
Module size: 40 mm × 30 mm. Please download the assembly diagram for exact numbers.
Mating height with standard connectors: 8 mm
PCB thickness: 1.6 mm
Highest part on PCB: approximately 2.5 mm. Please download the step model for exact numbers.
...
Overview
Content Tools