Versions Compared

Old Version 6

changes.mady.by.user Jan Kumann

Saved on

compared with

New Version 7

changes.mady.by.user Jan Kumann

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Block Diagram

Main Components

Image Modified

Image Modified

  1. Xilinx Zynq XC7Z010 All Programmable SoC, U1
  2. 512 MByte DDR3L SDRAM, U8
  3. Lattice Semiconductor MachXO2 System Controller CPLD, U11
  4. Dual high-speed USB to multipurpose UART/FIFO, U3
  5. 2 Kbit Microwire compatible serial EEPROM, U6
  6. Low-power, programmable oscillator @ 12.000000 MHz, U7
  7. Ultra-low capacitance double rail-to-rail ESD protection diode ,U4
  8. Micro-USB 2.0 B receptacle, J1
  9. Green LED (GLED), D1
  10. Red LED (RLED), D2
  11. DSI LCD connector, J4
  12. JTAGENB, when low, TDO, TDI, TMS and TCK function as GPIOs, J15
  13. Fiducial mark PM2
  14. External I2C bus with interrupt signal and power line, J2
  15. Low-voltage 4-channel I2C and SMBus multiplexer with interrupt logic, U10
  16. 2x20 pin 2.54 GPIO header, J8

  17. 128 Mbit (16 MByte) 3.0V SPI Flash memory, U5

  18. USB 2.0 Hub and 10/100 Ethernet controller, U2
  19. External reset
  20. 2 Kbit Microwire compatible serial EEPROM, U9
  21. PUDC of Zynq, active low enables  internal pull-ups during configuration on all SelectIO pins
  22. Dual USB A receptacle, J12. Also fiducial mark PM1
  23. Dual USB A receptacle, J11
  24. Low power programmable oscillator @ 25.000000 MHz, U13
  25. Molex’s miniature traceability S/N pad for low-cost, unique product identification
  26. RJ-45 Ethernet connector with 10/100 integrated magnetics, J10. Also fiducial mark PM3
  27. 3.5mm RCA audio jack, J7
  28. 1A PowerSoC synchronous buck regulator with integrated inductor (3.3V), U20
  29. 1A PowerSoC synchronous buck regulator with integrated inductor (1.8V), U19
  30. ZIF FFC/FPC CSI-2 camera connector, J3
  31. HDMI connector, J6

  32. Common mode filter with ESD protection, D8

  33. Common mode filter with ESD protection, D9

  34. 1A PowerSoC synchronous buck regulator with integrated inductor (1.35V), U16
  35. Additional external +5V power supply connector, J5

  36. Highly integrated full featured hi-speed USB 2.0 ULPI transceiver, U18

  37. Low-power programmable oscillator @ 33.333333 MHz, U14
  38. Ultra-low supply current voltage monitor with optional watchdog, U22
  39. Fiducial mark PM4
  40. Micro SD memory card connector with detect switch, J9
  41. JTAG interface, TP1 (TDI), TP3 (TDO), TP5 (TCK), TP7 (TMS)
  42. 1A PowerSoC synchronous buck regulator with integrated inductor (1.0V), U17
  43. Fiducial mark PM6
  44. 0.5A dual channel current-limited power switch, U15
  45. 0.5A dual channel current-limited power switch, U21
  46. Fiducial mark PM5

...