Page History
...
Following table describes how to configure the base-board supply-voltages by jumpers:
Base-board Supply Voltages | VCCIOA | VCCIOD |
|---|---|---|
| 1.8V | J26:1-2 | J27:1-2 |
| 2.5V | J26:3-4 | J27:3-4 |
| 3.3V | J26:5-6 | J27:5-6 |
Table 6: Configuration of base-board supply-voltages via jumpers. Jumper-Notification: 'Jx: 1-2' means pins 1 and 2 are connected, 'Jx: 3-4' means pins 3 and 4 are connected, and so on.
| Note |
|---|
Take care of the VCCO voltage ranges of the particular PL IO-banks (HR, HP) of the mounted SoM, otherwise damages may occur to the FPGA. Therefore, refer to the TRM of the mounted SoM to get the specific information of the voltage ranges. It is recommended to set and measure the PL IO-bank supply-voltages before mounting of TE 4 x 5 module to avoid failures and damages to the functionality of the mounted SoM. |
Technical Specifications
Absolute Maximum Ratings
...
Board operating temperature range depends also on customer design and cooling solution. Please contact us for options.
Weight
ca. 32 g - Plain board
Hardware Revision History
...
| Date | Revision | Authors | Description | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Ali Naseri | current TRM for TEBA0841-01 | |||||||||||
| 2017-01-30 | 0.1 | Ali Naseri | Initial document |
...
Overview
Content Tools