Versions Compared

Old Version 35

changes.mady.by.user Jan Kumann

Saved on

compared with

New Version 36

changes.mady.by.user Jan Kumann

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • This product should be operated only by qualified electrical specialist.
  • Never leave operating board unattended.
  • There is a possible risk of burns due to the hot surfaces while operating the Board. Reason for this may could be the high currents present in the motor driving outputs.
  • All externally connected power sources must be SELV protected (Separated or Safety Extra Low Voltage).
  • All wiring and installation should be performed only with all external power sources switched OFF or disconnected.
  • No rewiring wiring or mechanical setup changes should be performed while the board is operating.
  • The product is rated for indoor, dry environment use only.
  • The product is intended to be used only in horizontal position on a non-conducting and non-inflammable surface.
  • The mechanical setup must ensure that device is the board and all of its parts are firmly fixed in place and to prevent accidental or unwanted movement of its parts(e.g. sliding, falling. etc.).

Signals, Interfaces and Pins

...

Make sure that the Isolating PCB Cover is overlapping the conducting material by a minimum of 20 mm.

Initial

...

Operation

To use a separate power supply for the motor supply perform the following steps:

  1. Disconnect the reference motor board TEC0060 by unmounting its screws and the encoder cable from J10.
  2. Mount the delivered 30A fuse to the connectors J5 and J6 with the delivered M5 screws.
    1. For lower supply current requirements of the used motor a fuse with a suitable lower current rating integrated in the supply wiring is recommended.
  3. Connect with cable lugs the DC of +5..48V to J6 and the corresponding GND to J1.
    1. The cable length is limited to 3m.
  4. Connect the three motor phases to J2 (A), J3 (B) and J4 (C).
    1. The cable length is limited to 3m.
  5. Optional: connect Connect the encoder to J10 or J11 and set jumper field according to signal specification : (differential or single ended. See section TODO for details).

Power-On Sequence

Any power sequence of the three supply sources is allowed:

...

For easy connection of the reference Motor and Encoder to the Driver board Board a special Motor Adapter Board TEC0060 is included in the EDDP Kit.

...