Page History

...

Make sure that the Isolating PCB Cover is overlapping the conducting material by a minimum of 20 mm.

Initial Operation

To use a separate power supply for the motor supply perform the following steps:

Prepare the EDPS board as follows:

1. It is recommended to select fuse rating according to the motor and power supply to ensure proper function of the fuse. Depending on the current supplying capability of the power supply the delivered 30A fuse can be too powerful to be effective protection in the case of overcurrent.
2. Mount the selected
3. Disconnect the reference motor board TEC0060 by unmounting its screws and the encoder cable from J10.
4. Mount the delivered 30A fuse to the connectors J5 and J6 with the delivered M5 screws delivered.For lower supply current requirements
5. Use at most 3m long cable with lugs to connect the positive terminal of the used motor a fuse with a suitable lower current rating integrated in the supply wiring is recommended.Connect with cable lugs the DC of motor power supply to J6 (DC +5..48V to J6 ) and the corresponding GND negative terminal to J1 (0V).
6. The cable length is limited to 3m.
7. Connect Use at most 3m long cable to connect the three motor phases to J2 (A), J3 (B) and J4 (C).The cable length is limited to 3m
8. Connect 12V power supply to J7 (12V). In the case motor power supply voltage is 12V as well, one power supply can be used.
9. Optional: Connect the encoder to J10 or J11 and set jumper field J13 according to the signal specification (either to differential or to single ended )configuration.

Power-On Sequence

Any power sequence of the three supply sources is allowed:

...

For easy connection of the reference Motor and Encoder to the Driver EDPS Board a special Motor Adapter Board TEC0060 is included in the EDDP Kit. See the EDDP User Manul for the instructions for further instructions on how to use it.

Figure 8: Reference Motor Board TEC0060 with the Motor attached.

...