Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Table of contents

Table of Contents

General instructions


CPLD Access  

Set B2B Pin JM1-89 (JTAGEN) to VDD (3.3V)


With TE0701:

  • not possible on TE0701-01 up to TE0701-06

With TE0703 and TE0703 default CPLD firmware:

  1. Connect MiniUSB cable to J4
  2. Set DIP Switch S2-2 to OFF and S2-3 to ON position, see TE0703 CPLD - CC703S#CC703S-JTAG
  3. Power ON the board
  4. Run "Lattice Diamond Programmer"
  5. Select "Create new project from JTAG chain" and press "OK"

With TE0705:

  1. Connect MiniUSB cable to J7
  2. Set DIP Switch S3-ENJTAG, S3-M1 and S3-M2 to ON position, see TE0705 CPLD#JTAG
  3. Power ON the board
  4. Run "Lattice Diamond Programmer"
  5. Select "Create new project from JTAG chain" and press "OK"

With TE0706:

  1. Connect MiniUSB cable to XMOD
  2. Set DIP Switch S1-2 to OFF position, see TE0706 TRM#4-bitDIP-switch
  3. Power ON the board
  4. Run "Lattice Diamond Programmer"
  5. Select "Create new project from JTAG chain" and press "OK"

...

Available CPLD Firmware

  • TE0820 TE0713 CPLD - Firmware description with different Variants
      JTAG / QSPI / SD Boot Modi - In planning and currently not available: Use CPLD Pin 23 (NOSEQ) as second Boot Mode pin. This need 7 Series 4x5 Carrier CPLD Firmware update.

Download

  • TE0713/<PCB Revision>/Firmware/
    • Use files from the subfolders of your PCB revision

General instructions

Include Page
Lattice CPLD Firmware Update
Lattice CPLD Firmware Update