Page History
...
Connector JB1 (2 x 6 pin header) is compatible with XMOD JTAG adapter TE0790. This adapter can be inserted from top onto the TE0725, if JB1 is fitted with male pin header. Optionally JB1 can be fitted with pin header from bottom, in that case the JTAG cable connector must be on the base board. When using XMOD-JTAG in JB1 then additionally USB UART is usable, and the push-button on XMOD works as configuration reset.
Recommended TE0790 (XMOD) DIP-switch settings :
- S2-1: ON
- S2-2: OFF
- S2-3: OFF
- S2-4: OFF
When using XMOD-JTAG please check the switch settings on XMOD to be sure the power and I/O reference are supplied correctly. TE0790 can be in some cases used to power up TE0725 (other TE0790 DIP settings), however this is not recommended. TE0790-01 can not supply enough power for TE0725 (LED may blink but the module is not operating properly, especially in case of larger and more sophisticated designs).
...
Date | Revision | Contributors | Description |
---|---|---|---|
2018-01-11 | John Hartfiel | Minor formatting. | |
2017-06-07 | v.60 | Jan Kumann |
|
2017-01-27 | V v.57 | Jan Kumann |
|
2017-01-12 | V46 v.46 | Jan Kumann |
|
2016-12-15 |
| Thorsten Trenz |
|
2016-12-09 | V40 v.40 | Jan Kumann |
|
2016-12-02 | V1 v.1 | Antti Lukats |
|
Disclaimer
Include Page | ||||
---|---|---|---|---|
|