Page History
...
DIP-Switches
S1
Switch | Description |
---|---|
1 | SC JTAGEN (OFF: MAX 10, ON SoC) |
2 | EEPROM WP (Write protect, ON active) |
3 | FPGA PUDC (ON: internal pull-up resistors enabled, OFF: floating) |
4 | SC Switch (Reserved for future use) |
S2
Switch | Description |
---|---|
1 | Boot Mode 3Boot Mode 0 |
2 | Boot Mode 12 |
3 | Boot Mode 21 |
4 | Boot Mode 30 |
See Zynq UltraScale+ Device Technical Reference Manual page 236 for full boot modes description. Most common modes are
Boot Mode | SW1SW2:41 | SW1SW2:32SW1 | SW2:23 | SW1SW2:14 |
---|---|---|---|---|
JTAG Boot Mode | ON | ON | ON | ON |
Quad-SPI | ON | ON | OFF | ON |
SD Card | ON | OFF | ONOFF | OFF |
S2
Switch | Description |
---|---|
SC JTAGEN | |
2 | EEPROM WP (Write protect) |
3 | FPGA PUDC |
4 | SC Switch (Reserved for future use) |
LEDs
LED | Signal | Chip | Pin | Description |
---|---|---|---|---|
Front panel LED 1 (Red) | LED_FP_1 | FPGA U1 | AF15 | PL User defined LED |
Front panel LED 2 (Green) | LED_FP_2 | FPGA U1 | AG15 | PL User defined LED |
Front panel LED 3 (Green) | LED_FP_3 | FPGA U1 | AE15 | PL User defined LED |
Front panel LED 4 (Green) | LED_FP_4 | SC U18 | M4 | Power Good |
...
Board has USB-UART bridge based on FTDI FT2232 chip. Use of this feature requires that USB driver is installed on your host PC. UART0 with MIO 22 .. 23 should be selected in "Zynq UltraScale+ MPSoC" configuration.
Connected device depends on JTAGEN DIP (S1-1)
draw.io Diagram | ||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Reference Designs
Notes
Overview
Content Tools