Page History
...
- TEBA0841 has no dedicated power plug connector for 3.3V main power. External Power Supply must be connected to J17, J20, J4 or J3 3.3V Pin. Do not use XMOD for power supply.
- TEBA0841-REV01 VCCIOB and VCCIOC are not connected.
- (6) Works, but without carrier board modification out of specification: TE0706 SD Levelshifter powered fix by 1.8V, TE0820 SD MIO-Bank by 3.3V.
- (7) SD signals only, no SD-Card connector
- (8) CLK not connected on TE0710
- (9) Check schematics or TE Master Pinout Excel Sheet for detailed connection and IO Bank power supply
- (10) With TEBA0841-01 is Boot Mode not selectable, please contact Trenz Electronic Support, if you need a Zynq or ZynqMP Module with TEBA0841-1. With TEBA0841-2 it's usable.
- (11) MGT polarity is swapped
TEF1002
| FMC | FMC Vadj | SFP | SATA | PCIe | USB Host | SD Card | Ethernet | FFA & FFB | USB UART | USB JTAG | |
|---|---|---|---|---|---|---|---|---|---|---|---|
| TE0710 |  , no MGT, 19 x diff pair / 38 x IO | |  | | | | , 3.3V B16 I/O | | | | |
| TE0711 | , VCCIO34 B34 I/O on MGT | | | | | , device only | , 1.8V B16 I/O | , B34 I/Os | | | |
| TE0712 | |  | | | | , B14 3.3V I/Os | , 1.8V B13 I/O | | | | |
| TE0713 | | | | | | , device only | , 1.8V B13 I/O | , B13 I/Os | | | |
| TE0715 | | | | | | | | | | | |
| TE0715-30 | | , Max 1.8V | | | | | | | | | |
TE0720 (12) | , VCCIO34 B34 I/O on MGT | | | | | | | | | | |
| | | | | , B14 3.3V I/Os | , MGTs | , MGTs | | | | |
| TE0820 (13) | |  , Max 1.8V | | | | | | | | | |
| TE0841 | | , Max 1.8V | | | | , B65 3.3V I/Os | , MGTs | , MGTs | | | |
- (12) FMC_VADJ powers VCCIOC connected to power input of Bank 34 VCCO34 on TE0720 needed to start up. In standard Firmware dip S3-2 can be used to switch ON FMC_VADJ without FMC installed.
- (13) FMC_VADJ powers VCCIOC connected to power input of Bank 65 VCCO_65 and VDDO0 of CLK0 on TE0820. In standard Firmware dip S3-2 can be used to switch ON FMC_VADJ without FMC installed. Select VADJ_FMC 1.8V (HP bank)!
...
Overview
Content Tools