Table of contents
Available CPLD Firmware
- TEF1002 SC CPLD MAX10 - Firmware description
- Default delivered Firmware
CPLD Access
- Place CR00140 on CRUVI carrier.
- Make sure that JTAGEN pin on J9-57 is NOT driven low by the carrier.
- Use TEI0004 ARROW USB Programmer2 and connect to J10, or connect signals: TCK, TDO, TMS, TDI, Ref. I/O-voltage (3.3V), GND to your quartus compatibel programmer.
- Connect programmer via usb to your PC.
- Power up carrier, so that +3.3V_D is powered by 3.3V.
General instructions
MAX 10 Firmware Update - General Requirements
- Quartus Prime software, available for free (lite version) on https://www.intel.de/
- Arrow USB Programmer Driver
- Quartus compatible JTAG programmer, for example:
- TEI0004 - Arrow USB Programmer2 or carrier board with FTDI for JTAG
- Other JTAG Programmer compatible with Quartus Programmer
- JTAG must be connected to FPGA JTAG
- Correct Firmware (*.pof file) from Download area
MAX 10 Firmware Update - General Procedure
Important:
- Connect only one JTAG device to host PC.
- Close all other JTAG programs.
Procedure:
- Enable FPGA JTAG access (see JTAG section on Firmware description)
- Connect JTAG
- Power on system
- Open Quartus Prime
- Open Quartus Programmer from top menu: Tools → Programmer
- Select from Programmer top menu: Edit → Hardware Setup
- Select via the drop down menu: Arrow-USB-Blaster [USB0] (Installation of Arrow USB Programmer needed) and close the window
- Click Add File...
- Select correct Firmware from Download area and press Open
- Click Start to program the device
More information are available on the Firmware description.
Overview
Content Tools