You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 3
Next »
The Xilinx Spartan-3A DSP FPGA on the TE0320 can be configured in the following ways:
- B2B connector
- JTAG
- Slave Parallel (SelectMAP)
- Slave Parallel
- 6-pin JTAG header connector
- SPI Flash memory
For further information on Xilinx Spartan-3A DSP configuration modes, please consult the documentation listed in chapter 17 Related Materials and References.
The SPI Flash memory can be programmed in the following ways:
- B2B connector (SPI direct; only if iMPACT GUI is version 11.x or below, see Xilinx AR#36156)
- FPGA
- JTAG (SPI indirect)
- USB bus (Firmware/Bitstream Upgrade Tool)
Figure 43: configuration modes overview.