You can use CyConsole and CyControl to directly program the .iic Firmware file into the USB FX2 microcontroller's RAM.
Add 2 images.
if the module exit from reset or is powered on, the IIC EEPROM content program/configure the USB FX2 microcontroller RAM
You can use CyConsole and CyControl to directly program the .iic Firmware file into the IIC EEPROM connected to USB FX2 microcontroller.
Add 2 images.
The firmware actually changes (it runs on USB FX2 microcontroller's RAM) only when
The Xilinx Spartan-3E FPGA on the TE0300, Xilinx Spartan-3A DSP FPGA on the TE0320, Xilinx Spartan-6 FPGA on the TE0630 can be configured in the following ways:
For further information on
The bit-stream for the FPGA is stored in the SPI Flash. To use this bit-stream source FPGA configuration option is set to “Master Serial/SPI”. See 2.8 SPI Flash for additional information.
SPI Flash can be programmed in several ways:
Direct programming by USB controller (usually done by Firmware Upgrade Tools like Python OpenFut and C# OpenFutNet).
Indirect SPI programming via FPGA pins, controlled by JTAG (can be done using Xilinx iMPACT). See Appendix A. Indirect SPI Programming using iMPACT.
Direct SPI programming by FPGA, using an SPI core (FPGA project should contain SPI interface core and software to work with it: only if iMPACT GUI is version 11.x or below, see Xilinx AR#36156)).
SPI Flash can be programmed using the following connection: