You can use CyConsole and CyControl to directly program the .iic Firmware file into the USB FX2 microcontroller's RAM.
Add 2 images.
if the module exit from reset or is powered on, the IIC EEPROM content programs/configures the USB FX2 microcontroller RAM
You can use CyConsole and CyControl to directly program the .iic Firmware file into the IIC EEPROM connected to USB FX2 microcontroller.
Add 2 images.
The firmware actually changes (it runs on USB FX2 microcontroller's RAM) only when
The Xilinx Spartan-3E FPGA on the TE0300, Xilinx Spartan-3A DSP FPGA on the TE0320, Xilinx Spartan-6 FPGA on the TE0630 can be configured in the following ways:
SPI Flash memory (see the next section)
For further information on
TE0320 | TE0300 and TE0630 |
---|---|
The bit-stream for the FPGA is stored in the SPI Flash. To use this bit-stream source FPGA configuration option is set to “Master Serial/SPI”. See 2.8 SPI Flash for additional information.
SPI Flash can be programmed in several ways:
Direct programming via USB controller; it is usually done by Firmware Upgrade Tools like Python OpenFut and C# OpenFutNet.
Indirect SPI programming via FPGA pins; it is done by Xilinx iMPACT via JTAG. See Appendix A. Indirect SPI Programming using iMPACT.
Direct SPI programming via FPGA pins; the FPGA project should contain SPI interface core and the software to work with it (SPI interface and SW required are automatically created by Xilinx iMPACT tool). Only if Xilinx iMPACT tool is version 11.x or below, see Xilinx AR#36156.
SPI Flash can be programmed using the following connection:
TE0320 | TE0300 and TE0630 |
---|---|