Configuration via USB bus

To configure a TE USB FX2 module via USB bus, there are different procedures to follow according to module status and purpose of use.

See OpenFutNet, Firmware Tools Comparison and recovery boot.

For instance, a full quality control test already performed at Trenz Electronic laboratory premises requires all the following steps to be performed:

1. Cypress USB generic device driver installation;
2. USB FX2 microcontroller large EEPROM programming;
3. specific USB device driver installation;

4. an *.iic file generation/download;

5. a firmware upgrade tool (Cypress tools: CyConsole or CyControlCenter TE tools: OpenFut, OpenFutNet or FX2EEPROMProgrammer) utilization.

6. reference bitstream file written on SPI Flash  ?????

   step	first development cycle	following development cycles	EEPROM recovery (boot recovery)	quality control (lab test)
   (1)			●	●
   (2)			●	●
   (3)	●			●
   (4)	●	●		●
   (5)	●	●		●
   (6)	●	●		●
   (7)		●		●

   (7) custom bitstream file written on SPI Flash ????? is obviously not performed during quality control.

   Configuration steps via USB bus according to module status and purpose of use.